a "build it yourself" PVC upraised dog bed, off the floor to keep
clean and sanitary. Free picture and PVC project plans.
Click here for special fitting
Raised Dog Bed
"This is a raised doggie bed that I made
recently for my daughter's dog using 1 inch pvc pipe and fittings for the
foundation. Instead of gluing the joints, I used screws. Once the foundation
was completed, I finished it off using 1/2 inch pvc pipe to support the
pre-measured doggie pad for good support. I added rubber leg tips on all
legs to prevent it from sliding around, especially on a wooden floors each
time the dog gets on and off. Cats love it too. Hope this inspires a few dog
and cat owners."
Built by Ray Hamel
Return to pictures of PVC projects